Professional guide: how to install a LED lamp plug
Check the lamp with wire port is substantially flush with the port LED lights twist may cause relative sliding conductor and external lights with plastic part. If the lights with the port, which leads many to grow the port, docking lights with lamp plugs directly is likely to cause a short circuit, causing burning lamp with lamp plug even lights, you will encounter this situation, please grow a little trim wire port can. Be careful, if you cut more, the meter will cut broken, so be sure to look at the back of the line cut lights.
Do not cut into the inside of the lamp beads and lights with no loops. Be sure to pay attention to the lamp with internal lines. Hair cut and then connected to the lamp plug, you can point the light with it. Open LED lights with lamp plug plastic cover. If you do not turn on the light, then connected with cover, even if it is difficult to take a good professional, so please do not be bothered.
Lights with lights for the quasi- wire tie into the lights inside. The lamp plug in, check lights are lamp plugged; If all the bright lights, Congratulations, you pick good; If the LED is not lit the lamp with fully explained completely not connected; If some bright LED lights with some LED is not lit or lights with the middle one meter does not shine, but also the first or the last one meter or so the situation does not shine, it only shows that there is no lamp plug connected.
Be sure all lights with LED lights, after all, and then covered with the cover can be. Finally, install the LED lights. Wiring LED lights with LED lights with the general voltage DC 12V, and therefore requires the use of switching power supply, according to the size of the power supply and connection length LED lights to be.
Wiring monochrome 5050 SMD LED light strip is to distinguish between positive and negative, in general we provide good welding power lamp plug directly into us like a lamp with a power above, if you do not want each LED lights are used a power to control, you can buy a larger power supply to do the main power switch, and then all the LED lights up in parallel with the input supply all unified by the total switching power supply.